MCC TM Micro Commercial Components omponents 20736 Marilla Street Chatsworth !"# $ % !"# Features * * * * * FR204-TS01 2 Amp Fast Recovery Rectifier 400 Volts Low Cost Low Leakage Low Forward Voltage Drop High Current Capability Fast Switching Speed For High Efficiency Maximum Ratings * * DO-15 Operating Temperature: -55C to +150C Storage Temperature: -55C to +150C MCC Catalog Number Device Marking FR204-TS01 --- Maximum Recurrent Peak Reverse Voltage 400V Maximum RMS Voltage 280V Maximum DC Blocking Voltage 400V D A Cathode Mark B Electrical Characteristics @ 25C Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time Typical Junction Capacitance IF(AV) 2A TA = 55C IFSM 60A 8.3ms, half sine VF 1.25V IFM = 2.0A; TA = 25C IR 5.0A 100A TA = 25C TA = 100C Trr 100ns CJ 40pF IF=0.5A, IR=1.0A, Irr=0.25A Measured at 1.0MHz, VR=4.0V D C DIMENSIONS DIM A B C D INCHES MIN .230 .104 .026 1.000 MAX .300 .140 .034 --- MM MIN 5.80 2.60 .70 25.40 MAX 7.60 3.60 .90 --- NOTE *Pulse Test: Pulse Width 300sec, Duty Cycle 1% Revision: 3 www.mccsemi.com 2003/03/19 MCC FR204-TS01 Figure 1 Typical Forward Characteristics Micro Commercial Components 20 Figure 2 Forward Derating Curve 10 3.0 6 4 2.5 2 25C Amps 2.0 1 .6 1.5 Amps .4 1.0 .2 .5 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 0 50 75 100 125 150 175 C .02 .01 .4 .6 .8 1.0 1.2 Average Forward Rectified Current - Amperesversus Ambient Temperature - C 1.4 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ=25C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 Junction Capacitance - pFversus Reverse Voltage - Volts Revision: 3 www.mccsemi.com 2003/03/19 TM MCC FR204-TS01 TM Micro Commercial Components Figure 4 Maximum Non-Repetitive Forward Surge Current 90 75 60 45 Amps 30 15 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50 10 trr +0.5A 0 Pulse Generator Note 2 25Vdc 1 Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Revision: 3 Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.mccsemi.com 2003/03/19