Thyristors Datasheet
© 2021 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: GD. 02/12/21
1
2N6504 Series
Surface Mount – 50 - 800V
Glass Passivated Junctions
for Greater Parameter
Uniformity and Stability
Small, Rugged, Thermowatt
Construction for Low Thermal
Resistance, High Heat
Dissipation and Durability
Blocking Voltage to 800 Volts
300 A Surge Current
Capability
Pb−Free Package is Available
Features
The 2N6504 is designed primarily for half-wave AC control
applications, such as motor controls, heating controls and power
supply crowbar circuits.
Description
Additional Information
Pin Out
TO-220AB
Case 221A
Style 4
1
3
2
4
Functional Diagram
A
G
K
Pb
Resources Accessories Samples
Thyristors Datasheet
© 2021 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: GD. 02/12/21
2
2N6504 Series
Surface Mount – 50 - 800V
Rating Symbol Value Unit
Peak Repetitive Off-State Voltage (Note 1)
(Gate Open, Sine Wave 50 to 60 Hz, TJ = 25 to 125°C)
2N6504
2N6505
2N6507
2N6508
2N6509
VDRM,
VRRM
50
100
400
600
800
V
On-State RMS Current (180° Conduction Angles; TC = 85°C) IT (RMS) 25 A
Average On-State Current (180° Conduction Angles; TC = 85°C) IT (AV) 16 A
Peak Non-repetitive Surge Current
(1/2 Cycle, Sine Wave 60 Hz, TJ = 100°C) ITSM 250 A
Forward Peak Gate Power (Pulse Width ≤ 1.0 µs, TC = 85°C) PGM 20 W
Forward Average Gate Power (t = 8.3 ms, TC = 85°C) PG(AV) 0.5 W
Forward Peak Gate Current (Pulse Width ≤ 1.0 µs, TC = 85°C) IGM 2.0 A
Operating Junction Temperature Range TJ-40 to +125 °C
Storage Temperature Range Tstg -40 to +150 °C
Maximum Ratings (TJ = 25°C unless otherwise noted)
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the
Recommended Operating Conditions may affect device reliability.
1. VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages
shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded.
Thermal Characteristics
Rating Symbol Value Unit
*Thermal Resistance, Junction to Case RƟJC 1. 5 °C/W
*Maximum Lead Temperature for Soldering Purposes, 1/8” from case for
10 seconds TL260 °C
* Indicates JEDEC Registered Data.
Electrical Characteristics - OFF (TC = 25°C unless otherwise noted)
Characteristic Symbol Min Ty p Max Unit
†Peak Repetitive Blocking Current
(VAK = VDRM = VRRM; Gate Open)
TJ = 25°C
TJ = 125°C
IDRM,
IRRM
- - 10 µA
- - 2.0 mA
Electrical Characteristics - ON (TC = 25°C unless otherwise noted; Electricals apply in both
directions)
*Indicates JEDEC Registered Data
2. Pulse Test: Pulse Width ≤ 300 µsec, Duty Cycle ≤ 2%.
Characteristic Symbol Min Ty p Max Unit
* Forward On-State Voltage (Note 2) (ITM = 50 A) VTM 1. 8 V
* Gate Trigger Current (Continuous dc)
(VAK = 12 Vdc, RL = 100 )
TC = 25°C
TC = -40°C IGT
9.0 30 mA
75
* Gate Trigger Voltage (Continuous dc) (VAK = 12 Vdc, RL = 100 Ω, TC = -40 °C) VGT 1. 0 1. 5 V
Gate Non-Trigger Voltage (VAK = 12 Vdc, RL = 100 Ω, TJ = 125°C) VGD 0.2 V
*Holding Current (VD = 12 Vdc,
Initiating Current = 200 mA, Gate Open)
TC = 25°C
TC = -40°C IH
-18 40 mA
- - 80
* Turn-On Time (ITM = 25 A, IGT = 50 mAdc) tgt - - - µs
Turn-Off Time (VRM = rated voltage) (ITM = 25 A, IR = 25 A) tq- - - µs
Thyristors Datasheet
© 2021 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: GD. 02/12/21
3
2N6504 Series
Surface Mount – 50 - 800V
Figure 1. AverageCurrent Derating Figure 2. Maximum On-State Power Dissipation
Dynamic Characteristics
Characteristic Symbol Min Ty p Max Unit
Critical Rate of Rise of Off-State Voltage (Gate Open, Rated VDRM,
Exponential Waveform) dv/dt(c) 50 V/µs
Voltage Current Characteristic of SCR
Symbol Parameter
VDRM Peak Repetitive Forward Off State Voltage
IDRM Peak Forward Blocking Current
VRRM Peak Repetitive Reverse Off State Voltage
IRRM Peak Reverse Blocking Current
VTM Maximum On State Voltage
IHHolding Current
Quadrant 1
Main Terminal 2+
VTM
IH
IDRM at VDRM
+V
oltage
Off State
Quadrant 3
Main Terminal 2-
+Current
On State
IRRM at VRRM
IH
VTM
Thyristors Datasheet
© 2021 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: GD. 02/12/21
4
2N6504 Series
Surface Mount – 50 - 800V
Figure 4. Maximum Non−Repetitive Surge CurrentFigure 3. Typical On−State Characteristics
Figure 5. Thermal Response
Thyristors Datasheet
© 2021 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: GD. 02/12/21
5
2N6504 Series
Surface Mount – 50 - 800V
Figure 6. Typical Gate Trigger Current vs. Junction
Temperature
Typical Trigger Characteristics
Figure 7. Typical Gate Trigger Voltage vs. Junction
Temperature
Figure 8. Typical Holding Current vs.Junction
Temperature
Thyristors Datasheet
© 2021 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: GD. 02/12/21
6
2N6504 Series
Surface Mount – 50 - 800V
Dimensions Part Marking System
A
K
L
V
G
D
N
Z
H
Q
FB
12 3
4
PLANE
SEATING
S
R
J
U
T
C
Ordering Information
1. Dimensioning and tolerancing per ansi y14.5m, 1982.
2. Controlling dimension: inch.
3. Dimension z defines a zone where all body and lead irregularities are allowed.
Dim Inches Millimeters
Min Max Min Max
A0.590 0.620 14.99 15.75
B0.380 0.420 9.65 10.67
C0.178 0.188 4.52 4.78
D0.025 0.035 0.64 0.89
F0.142 0.147 3.61 3.73
G0.095 0.105 2.41 2.67
H0.110 0.13 0 2.79 3.30
J0.018 0.024 0.46 0.61
K0.540 0.575 13.72 14.61
L0.060 0.075 1.52 1.91
N0.195 0.205 4.95 5.21
Q0.105 0.115 2.67 2.92
R0.085 0.095 2.16 2.41
S0.045 0.060 1. 14 1.52
T0.235 0.255 5.97 6.47
U0.000 0.050 0.00 1.27
V0.045 --- 1. 15 ---
Z--- 0.080 --- 2.04
Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability of and test each product selected for their own applications. Littelfuse products are
not designed for, and may not be used in, all applications. Read complete Disclaimer Notice at http://www.littelfuse.com/disclaimer-electronics.
Pin Assignment
1 Cathode
2 Anode
3 Gate
4 Anode
TO-220AB
Case 221A
Style 3
1
3
2
4
YMAXX
2N650xG
AKA
Y =Year
M =Month
A =Assembly Site
AKA =Diode Polarity
G =Pb-Free Package
Device Package Shipping
2N6504 TO-220AB
1000 Units / Box
2N6504G TO-220AB
(Pb-Free)
2N6505 TO-220AB
2N6505G TO-220AB
(Pb-Free)
2N6505T TO-220AB
1000 Units / Box
2N6505TG TO-220AB
(Pb-Free)
2N6507 TO-220AB
1000 Units / Box
2N6507G TO-220AB
(Pb-Free)
2N6507T TO-220AB
1000 Units / Box
2N6507TG TO-220AB
(Pb-Free)
2N6508 TO-220AB
1000 Units / Box
2N6508G TO-220AB
(Pb-Free)
2N6508TG TO-220AB 1000 Units / Box
2N6509 TO-220AB
(Pb-Free) 1000 Units / Box
2N6509G TO-220AB
2N6509T TO-220AB
(Pb-Free) 1000 Units / Box
2N6509TG TO-220AB