Description
Features
n500 WATT PEAK POWER PROTECTION
nEXCELLENT CLAMPING CAPABILITY
nFAST RESPONSE TIME
Mechanical Dimensions
nTYPICAL IR < 1µA ABOVE 10V
n
GLASS PASSIVATED CHIP CONSTRUCTION
nMEETS UL SPECIFICATION 94V-0
Maximum Ratings
Peak Power Dissipation...PPK
TP = 1ms (Note 5)
Steady State Power Dissipation...PD
@ TL = 75°C
Non-Repetitive Peak Forward Surge Current...IFSM
@ Rated Load Conditions, 8.3 ms, ½ Sine Wave, Single Phase
(Note 3)
Forward Voltage @ 50A...VF
(Undirectional Only)
Weight...GRM
Soldering Requirements (Time & Temp)...ST
@ 300°C
Operating & Storage Temperature Range...TJ, TSTRG
SA5.0...170
Data Sheet
5.0V to 170V GPP TRANSIENT
VOLTAGE SUPPRESSORS
SA5.0...170
Units
Watts
Watts
Amps
Volts
Grams
......................................... 500 Min. ..........................................
............................................. 1 ...............................................
............................................. 70 ...............................................
............................................. 3.5 ...............................................
............................................. 0.4 ...............................................
............................................. 10 Sec. ...........................................
......................................... -55 to 175 .......................................... °C
Page 11-6
Min. to
Solder
NOTES: 1. For Bi-Directional Applications, Use C or CA. Electrical Characteristics Apply in Both Directions.
2. Lead Length .375 Inches.
3. 8.3 ms, ½ Sine Wave, Single Phase Duty Cycle, @ 4 Pulses Per Minute Maximum.
4. VBR Measured After IT Applies for 300 µs. IT = Square Wave Pulse or Equivalent.
5. Non-Repetitive Current Pulse. Per Fig. 3 and Derated Above TA = 25°C per Fig. 2.
Uni-Polar
Load
TVS
Device
TVS
Device
Load
Bi-Polar
.240
.255
1.00 Min.
.031 typ.
.120
.140
JEDEC
204-AC