SIEMENS LH1505, 'LH1520 : LH1522, LH1524 Dual 1 Form A Absolute Maximum Ratings T,=25C device is not implied at these or any other Conditions in Stresses in excess of the Absolute Maximum Ratings excess of those given in the operational sections of this can cause permanent damage to the device.. These are document. Exposure to Absolute Maximum Ratings for absolute stress ratings only. Functional operation of the extended periods of time can adversely affect reliability. Parameter Symibol |Test Conditions | LH1505 | LH1520 | LN1522 | LH1524 | Units Ambient Operating Ta _ ~40 to +85 | -40 10 +85 | 40 to +85 | 40 to + 85] C Temperature Range : Storage Temperature Range Tstg _ ~40 to +150 | -40 to +150 | -40 to +150] -40 to +150 | C Pin Soideririg Temperature Tg |t=10 s max 260 : 260 260 260 Oy Input/Output Isolation Test Vigo |t=1s 5300 5300 300 5300 Vrms Voltage ligo=10 pA max Pole to-Pole Isolation Voltage {Dry air, dust free, 1600 1600 1600 1600 Vv (S1 to s2yt at sea level LED Continuous Forward lp Se 50 50 50 50 mA Current . LED Reverse Voltage Va fins 10 pA 8 | 8 8 8 Vv dc or Peak ac Load Voltage VTL sS0pA 250 "350 200 400 Vv Continuous dc Load Current: I = One pole operating : 130 150 200 95 mA Two poles operating : oe 120 110 140 70 mA Peak Load Current lp [t=100'ms - * * * mA (single shot) . Output Power Dissipation Poiss | _ 600 600 600 600 mw (continuous) : * Reter to Current-Limit Parlormance Application Note for a discussion on relay operation during transient currents. t Breakdown occurs between the output pins external to the package Recommended Operating Conditions LOAD CURRENT (ma) LOAD CURRENT (mA) AMBIENT TEMPERATURE (C) AMBIENT TEMPERATURE (C) 8 LOAD CURRENT (mA} 8 8 o 20 80 AMBIENT TEMPERATURE (C) AMBIENT TEMPERATURE (C) LH1505, LH1520, LH1522, LH1524Electrical Characteristics T,=25C Minimumrand maximum values are testing require- ments. Typical values are characteristics of the device Symhboi Conditions ms for Switch Turn-off Leakage Current Capacitance (S1 te $2) {250 mA tott AMUNHS PDs [L=50 mA * Ron=W(50 mA) V (20 mA)/ 30 mA, tl,=100 mA, fie=10 mA. and are the result of engineering evaluations, Typical values are for information purposes only and are not part of the testing requirements. Values LH1505 LH1520 LH1522 LH124 Units The following information refers to the SSR Recommended Operating Conditions on the previous page. 1) Both relays on with equal toad currents. For single relay operation, refer to the LH1518 Recommended Operating Conditions graph. 2) Both relays on with equal load currents. For single relay operation, refer to the LH1500 Recommended Operating Conditions graph. 3) Both relays on with equal load currents. For single relay operation, refer to the LH1510 Recommended Operating Conditions graph. 4) Both relays on with equal foad currents. For single relay operation, refer to the LH1504 Recommended Operating Conditions graph. LH1805, LH1520, LH1522, LH1524 6G-27