(R) SEM IC O N DU C TO R DO-41 General Purpose Plastic Silicon Rectifier AXIAL LEAD DO-41 Specification Features: Case: Epoxy, Molded Weight: 0.4 gram (approximately) Finish: All external surfaces corrosion resistant and terminal leads are 1N400X readily solderable Y 1N4001 DEVICE MARKING DIAGRAM : TC1N4001~TC1N4007 : Tak Cheong Logo Lead and mounting surface temperature for soldering purposed: Y : Assembly site code (1, 2, 3...) 260 Max. for 10 seconds 1.16 inch from case Low reverse leakage, High forward surge capability Cathode indicated by polarity band Anode Cathode ELECTRICAL SYMBOL Absolute Maximum Ratings Parameter Maximum repetitive peak reverse voltage VRRM Maximum RMS voltage Maximum DC blocking voltage Maximum average forward rectifier current IF(AV) 0.375" (9.5mm) lead length at TA=75 Peak forward surge current 8.3mS single half sine-wave superimposed on reted load Maximum full load reverse current, IR(AV) full cycle average 0.375" (9.5mm) lead length TL=75 Operating Junction and storage temperature range Typical Thermal Resistance (note1) TA = 25C unless otherwise noted TC1N4001 TC1N4002 TC1N4003 TC1N4004 TC1N4005 TC1N4006 TC1N4007 Units 50 100 200 400 600 800 1000 V 35 70 140 280 420 560 700 V 50 100 200 400 600 800 1000 V 1.0 A 30 A 30 uA -50 to +150 C 60 C/W Note 1: Thermal resistance from junctiont ambient at 0.375" (9.5mm) lead length, P.C.B. mounted. Electrical Characteristics Device Type TC1N4001 TC1N4002 TC1N4003 TC1N4004 TC1N4005 TC1N4006 TC1N4007 BV @ IR (Volts) Min 50 100 200 400 600 800 1000 TA = 25C unless otherwise noted IR (uA) 5 5 5 5 5 5 5 IR @ VR (uA) Max 5 5 5 5 5 5 5 VR (Volts) 50 100 200 400 600 800 1000 VF Forward Voltage = 1.1 V Maximum @ IF = 1.0 A for all types CJ Typical Junction Capacitance = 15 pF at 4.0V, 1MHz April 2006 / A Page 1 TC1N4001 through TC1N4007 Series TAK CHEONG TAK CHEONG (R) SEM IC O N DU C TO R Ordering Information Device Package Quantity TC1N4001~TC1N4007 Bulk 1,000 TC1N4001~TC1N4007TB Tape and Ammo 5,000 TC1N4001~TC1N4007TR Tape and Reel 5,000 Others (...contact Tak Cheong sales representatives) Package Outline Package Case Outline D0-41 DO-41 DIM Millimeters Inches Min Max Min Max A 0.72 0.86 0.028 0.034 B 4.10 5.20 0.161 0.205 C 25.40 --- 1.000 --- D 2.04 2.71 0.080 0.107 Notes: 1. 2. All dimensions are within JEDEC standard DO-204AL. DO-41 polarity denoted by cathode band. April 2006 / A Page 2